We combine the following features into one design:

1. Safety: enhanced (width) lighting + protection of the front wheels

2. Practical use: front weight + integrated storage box

3. Design: in the colors of your tractor with your own logo.

Yes, the SafetyWeight Plus weights have a towing point in the top link support where a rope can be attached. We have tested this extensively, watch the video here:

The SafetyWeight Plus bumper will be delivered on a large pallet as shown in the picture and is already fully assembled.

There are 2 coupling positions for the bumper, supplied as standard in the front position (1). If the front linkage is compact and fully raised, the bumper may touch the linkage arm. The coupling position must then be moved to the rearmost position (2). Loosen the M27 bolt (key 41), move the nut inside the rail and tighten again.

The following weights are possible: 1300kg, 1500kg, 1800kg, 2000kg, or 2500kg. Selected weight cannot be adjusted afterwards. Need less weight? Look for our Safetyweight models from 300kg till 1100kg.

No, it is not possible to increase or decrease the weight afterwards.

As ballast we use small punch caps, residual material from perforated sheet. This in combination with concrete gives a strong and solid construction.

The storage box is 80 cm wide, 19 cm deep, 19 cm high at the front and 37 cm high at the rear. The volume is 55 liters.

No, protruding parts in front of the bumper are not safe, so the option is not possible.

This depends on the weight. 37 cm at 1300 and 1500 kg models, 48 cm at 1800, 2000 and 2500 kg models

Width is adjustable from 2.5 meter till 2.9 meter.

No, a tractor bumper is not mandatory in any country.

A few of accidents have now been reported in which the TractorBumper has undoubtedly limited the consequences.

Only subsidy in possible in Belgium, callled “VLIF”.  According to our data, subsidy is not possible in all other countries