We combine the following features into one design:

1. Safety: enhanced (width) lighting + protection of the front wheels

2. Practical use: front weight + integrated storage box

3. Design: in the colors of your tractor with your own logo.

Yes, the SafetyWeight weights have a towingpoint in the top link support where a rope can be attached. We have tested this extensively, watch the video here:

The XL-BOX bumper is delivered on a large pallet as shown and comes pre-assembled.

There are 2 coupling positions for the bumper, standard in the front position. If the front linkage is compact and fully raised, the bumper may touch the linkage arm. The ball position must then be moved to the position 2, more at the back Loosen the M27 bolt (key 41), move the nut inside the rail and tighten again.

400, 600 and 800kg toolbox size: 270 Liter 81 x 68 x 42 cm

1000 and 1100kg toolbox size: 340 Liter 80 x 82 x 53 cm

These weights are possible in combination with big toolbox:

• 400kg
• 600kg
• 800kg
• 1000kg
• 1100kg

No, it is not possible to increase or decrease the weight afterwards.

As ballast we use small punch caps, residual material from perforated sheet. This in combination with concrete gives a strong and solid construction.

In the side wings. Middle frame is full integrated storagebox.

This depends on the weight: 37 cm for models of 400, 600, and 800 kg, and 48 cm for models of 1000 and 1100 kg.

The width is adjustable from 2.5 to 2.9 meters.

No, a tractor bumper is not mandatory in any country.

A few of accidents have now been reported in which the TractorBumper has undoubtedly limited the consequences.

Only subsidy in possible in Belgium, callled “VLIF”.  According to our data, subsidy is not possible in all other countries